Are you a spammer
Please note, that the first 3 posts you make, will need to be approved by a forum Administrator or Moderator before they are publicly viewable.
Each application to join this forum is checked at the Stop Forum Spam website. If the email or IP address appears there when checked, you will not be allowed to join this forum.
If you get past this check and post spam on this forum, your posts will be immediately deleted and your account inactivated.You will then be banned and your IP will be submitted to your ISP, notifying them of your spamming. So your spam links will only be seen for an hour or two at most. In other words, don't waste your time and ours.
This forum is for the use and enjoyment of the members and visitors looking to learn about and share information regarding the topics listed. It is not a free-for-all advertising venue. Your time would be better spent pursuing legitimate avenues of promoting your websites.
The Ultimate Guide for the rest of us
by dragonfly » Thu May 26, 2011 10:43 pm
How do I get inkblot to work. I want to know my ink levels. I installed inkblot but nothing happens when I click on it.
-
dragonfly
- U.E. Pro
-
- Posts: 157
- Joined: Thu May 08, 2008 11:46 am
- Location: Ontario, Canada
- Age: 87
- Operating System: Ultimate Edition 3.2 32 BIT
by dragonfly » Fri May 27, 2011 12:09 am
Forget my post I just figured out that I don't need inkblot. I installed hplip and hplip gui and can read ink levels by opening hplip toolbox and then clicking on supplies.
-
dragonfly
- U.E. Pro
-
- Posts: 157
- Joined: Thu May 08, 2008 11:46 am
- Location: Ontario, Canada
- Age: 87
- Operating System: Ultimate Edition 3.2 32 BIT
Return to Newbie's Corner
Who is online
Users browsing this forum: No registered users and 0 guests